Conversion + protection
Converts rust into a corrosion-resistant layer.
One of the leading rust conversion solutions in Egypt
Convert rust into a paint-ready protective layer… no sanding required
INT Rust Converter chemically transforms iron oxide (Fe₂O₃) into a stable protective layer that functions as a primer. After curing, the surface is ready for direct coating without additional surface preparation.
6
Hours reaction
9
m² per liter
Brush
or Spray
Practical note: if rust is layered, flaky, or delaminated from the metal, remove the loose rust first. A converter is not magic—it is chemistry.
Why INT?
Reduce surface preparation and get a protective layer that provides an excellent base for coating.
Excellent paint base
Acts as a primer and can be coated after curing.
Easy application
Brush or spray application.
Saves time & cost
Less prep, faster work.
Water-miscible
Miscible with water (per datasheet).
Non‑toxic
Non‑toxic (with standard safety precautions).
How to use
- Cleaning Remove dust and loose/flaky rust.
- Apply Apply an even coat by brush or spray.
- Wait Allow 6 hours for full chemical conversion.
- Repeat (if needed) Apply a second coat if residual rust remains.
- Paint Paint directly over the treated surface without sanding.
Important: Best for light to medium rust. Remove heavily flaking/layered rust mechanically first, then apply the converter.
Technical data
Appearance
Clear
pH
< 3
Solubility
Miscible with water
Specific gravity @15°C
1.100 – 1.200
Toxicity
None (حسب الداتا شيت)
Coverage
1 لتر ≈ 9 م²
Composition
Contains Phosphorus (P), Manganese (Mn), Zinc (Zn), and Iron (Fe) in an acidic medium.
Safety guidance
- Keep away from direct sunlight and out of reach of children.
- Wear gloves and eye protection.
- Ensure good ventilation during application.
- In case of skin/eye contact: rinse immediately with water.
Available pack sizes
250 g
500 g
1 كg
20 كg
Request now / Ask a technical question
Send surface details (steel type, rust level, any flaking) and we will reply with clear application steps.
Email
info@tonneletoil.com
WhatsApp
Open WhatsApp
Frequently asked questions
Is sanding required before application?
No sanding is required. Only remove contaminants and loose/flaky rust.
Why does rust sometimes remain underneath?
Usually the rust was layered and delaminated. Remove loose scale so the product can reach the surface.
Can it be painted over?
Yes. After 6 hours, paint directly without sanding (per the datasheet).
Brush or spray?
Both. Choose based on area size and geometry.